Transfer case car Chevy Trailblazer 1

Transfer case — specifications
Tightening torques of threaded connections Nm Shift servomotor mounting bolts - 16 Bolts securing the transfer case to the gearbox - 48 Transfer case speed...

General information — transfer case
All-wheel drive models have a transfer case located behind the transmission. Torque from the engine is transmitted through the gearbox, transfer case and...

Transfer case control switch (models with electric shift mechanism)
1. Disconnect the negative battery cable. 2. When performing the procedure on a Chevy TrailBlazer, it is necessary to remove the instrument panel frame ( see...

Transfer case shift servomotor (models with electric shift mechanism)
1. Make sure the shift servomotor is in the two-wheel drive overdrive position. Raise the car and install vertical supports. 2. Remove the protective panels...

Transfer case speed sensors — performance check and replacement
The transfer case has three speed sensors. The first sensor is located on the front output shaft, and the second is located on the rear. The third sensor is...

Transfer case control unit (models with electric shift mechanism) — replacement
1. The transfer case control unit is located on the left behind the instrument panel. 2. Disconnect the negative battery cable. 3. Remove the body dashboard...

Oil seals — replacement
Note: This procedure applies to the front and rear output shaft seals. 1. Raise the vehicle and install vertical supports. 2. When replacing the front oil...

Transfer case — removal and installation
1. Disconnect the negative battery cable. 2. Raise the vehicle and install vertical supports. 3. If necessary, remove the gravel reflectors. 4. Drain the...

Transfer case repair — general information
Repairing a transfer case is quite a complicated procedure to do it yourself. In this case, it is necessary to disassemble and assemble many small elements. It...