2. Loosen the left front wheel nuts, raise the front of the car and install vertical supports. Remove the left front wheel.
3. Disconnect the wires from the starter connectors (see illustration).
13.3. Unscrew the nuts and disconnect the battery cable from the starter (A) and solenoid valve (IN) (This photo shows a top view, with the intake manifold removed for clarity; removal is done from under the wing)
4. Tighten the nut (top) and unscrew the bolt (lower), then remove the starter from under the wing (see illustration).
13.4. Unscrew the nut and remove the starter mounting bolt
5. Installation is carried out in the reverse order of removal. Tighten the starter fasteners to the required torques.
6. Install the wheel and secure it with nuts. Lower the vehicle onto a supporting surface and tighten the wheel nuts to the torque specified in the specifications chapter 1.