Car doors, locks and windows Chevy Trailblazer 1

Hinges and locks — maintenance
After every 5,000 km or once every three months, lubricate the hinges, latches and locks of the hood, side and rear doors with universal or special lubricant....

Windshield and fixed windows — replacement
These glasses are installed with precise fit in the openings relative to the body seals, and are held in their position by special adhesive materials. Removing...

Door trim panels — removal and installation
1. Disconnect the negative battery cable ( see chapter 1 ). 2. If the procedure is performed on the front door, pry and remove the power window switch block...

Doors — removal and installation
1. Remove the door trim panel ( see subsection 15 ). Disconnect the connectors and route them through the holes in the door so that the wires do not interfere...

Latch, lock cylinder and door handle — removal and installation
Latch 1. Raise the glass completely, then remove the door trim panel and the rear section of the weatherstripping strip ( see subsection 15 ). 2. Disconnect...

Door window glass — removal and installation
Warning: When performing the procedure in the door cavity, it is necessary to disconnect the power window electrical connector to prevent the possibility of...

Window regulator — removal and installation
Caution: Do not remove the power window motor from the power window mechanism. A replacement electric motor can only be purchased as a built-in element of a...

Tailgate and glass — removal and installation
Tailgate Note: The tailgate is a heavy and bulky body part. To successfully complete this procedure, at least two people are required. 1. Open the tailgate and...

Rear Door Panels, Lock Cylinder, Latch and Support Posts — Removal and Installation
Interior cladding panels 1. Open the window, then remove the plastic pins that secure the top trim panel and lower it onto the tilt window lock (see...