Vehicle Maintenance Chevrolet Tahoe 2 and 3

Maintenance intervals
On vehicles where the notification system is not used, the frequency of maintenance is carried out in accordance with the table "Maintenance interval". Note:...

Rules for performing work in the engine compartment
Oil Handling Precautions 1. Prolonged and often repeated contact with mineral oil leads to the washing off of natural fats from human skin and the occurrence...

Location of service items in the engine compartment
Location of service objects in the engine compartment for models Cadillac Escalade, Chevrolet Tahoe/ Suburban/Avalanche, GMC Yukon. 1 - air filter housing /...

Checking the engine oil level
If the vehicle is equipped with a message alert system, when the engine oil level needs to be checked, the system display will show the message "CHECK OIL...

Changing engine oil and oil filter
The oil change interval is 5,000 km on a new car or after an engine overhaul (break-in mode), then the frequency of replacement should be no more than 15,000...

Air filter
Depending on the configuration and year of manufacture, the air filter indicator may be installed on the vehicle. The indicator housing is usually located next...

Cooling liquid
Recommended coolant for cooling system (or concentrate) trademark DEX-COOL5. When using this coolant, under normal operating conditions, replace every 5 years...

Coolant replacement
Caution: The coolant contains ethylene glycol and an anti-corrosion agent. Since the radiator, cylinder head and coolant pump housing are cast from aluminum...

Fuel filter
Models since 2004 (fuel filter in the fuel tank) Attention: The fuel filter is an integral part of the fuel pump assembly located in the fuel tank and cannot...

Checking the condition of the battery
General recommendations The car can be equipped with both a serviced and maintenance-free type of battery. As a rule, the service life of a maintenance-free...

Removing and installing the battery
Models up to 2007 release 1. Disconnect a wire from the negative plug of the storage battery. 2. Remove a cover and disconnect a wire from the positive plug of...

Spark plug
Removal and installation 1. Disconnect the high voltage wire from the spark plug. A) Turn the tip of the spark plug wire half a turn. b) Pull the tip to...

Checking the pressure at the end of the compression stroke
1. Before checking, check the level and condition of the engine oil, the condition of the starter and the battery. 2. Before starting the verification...

Attachment drive belt
Checking drive belts Check the drive belt for damage and excessive wear and make sure it is properly seated in the pulley grooves. If the belt "squeals" or...

Automatic transmission fluid
On production models before 2007, the following automatic transmissions were used: Engine (body) automatic transmission (Pro code) 5.3 L V8 (L59) 4L60E (M30)...

Transfer box oil
On cars, depending on the configuration and year of manufacture, the following transfer boxes are installed: Models up to 2007 release: Borg Warner (BW) model...

Front axle gear oil
Level check 1. Raise the car. 2. Install the car body horizontally. 3. Inspect the front axle. Check for oil leaks. Repair leaks if necessary. 4. Clean...

Rear axle gear oil
Level check 1. Raise the car. 2. Install the car body horizontally. 3. Inspect the rear axle. Check for oil leaks. Repair leaks if necessary. 4. Clean surfaces...

Checking the brake fluid level
1. Check the brake fluid level in the brake fluid reservoir. The level must be between the marks "MAX" And "MIN". Brake fluid type - DOT3 or Delco Supreme 11...

Checking the fluid level in the reservoir of the power steering system
1. Install the car on a flat horizontal platform. Switch off the ignition and let the engine cool down. 2. Remove the reservoir cap of the power steering...

Catalog numbers of original spare parts
Below are the catalog numbers of the original spare parts most in demand during vehicle maintenance. Some numbers may vary (depending on the country of...

Reading and erasing diagnostic trouble codes
Reading and erasing fault codes is performed using a diagnostic tool. To do this, you must connect the diagnostic tool to the diagnostic socket located under...

Diagnostic Trouble Codes (GMT 800 models prior to 2007)
Diagnostic Trouble Codes (GMT 800 models until 2007) Code Possible fault location B0004 Vehicle speed signal - open circuit B0012 Passenger Airbag Stage 2 Low...

Diagnostic Trouble Codes (GMT 900 models since 2007)
Diagnostic Trouble Codes (GMT 900 models since 2007) Code Possible fault location B0000 Vehicle speed signal circuit B0012 Driver airbag, stage 1 B0013 Driver...