Power steering pump. 1 - power steering pump reservoir, 2 - reservoir cap, 3 - reservoir stud, 4 - reservoir stud, 5 - pump tube plug, 6 - sealing washer, 7 - flow control valve, 8 - flow control valve spring, 9 - pump housing seal, 10 - pump housing o-rings, 11 - pump reservoir o-ring, 12 - power steering pump, 13 - pump shaft seal, 14 - pump reservoir magnet.
Withdrawal
1. Remove the power steering pump pulley.
2. Raise the vehicle and place the safety stands under the frame.
3. Remove the engine oil pan protection bolts (if protection is set). Tightening torque 20 Nm.
4. Remove the oil pan protection.
5. Place a container under the engine to collect the oil.
6. Under the car, disconnect the pressure hose from the pump (2). Tightening torque 28 Nm.
7. Lower the car.
8. Remove clamps (3) And (5) attaching the pressure and return hoses to the pump, disconnect the hoses from the pump.
9. Disconnect the lower intermediate shaft from the steering mechanism.
10. Turn away a bolt of fastening of a back arm of the pump to the engine. Tightening torque 50 Nm.
11. Turn away bolts of fastening of a forward part of the pump. Tightening torque 50 Nm.
12. Remove the pump from the car.
13. Loosen the nuts (4) and remove from the pump (1) rear bracket (3).
Installation
14. Install in reverse order.