Withdrawal
1. Disconnect the connector (1) tailgate wiring. If the vehicle is equipped with a rear view camera, disconnect the camera connector under the vehicle.
2. Disconnect cables (2) side opening limiter.
3. With the help of an assistant, remove the tailgate.
Installation
4. Installation is carried out in the reverse order.
Adjustment
1. Close tailgate and determine tailgate offset.
2. If bead adjustment is needed, remove bead.
3. Mark the position of the bead hinges relative to the body.
4. Loosen the hinge bolts and move them to the desired position (up/down or forward/backward).
5. Temporarily tighten the hinge bolts. Install the tailgate and check that the adjustments are correct.
6. Finally tighten the hinge bolts. Tightening torque 40 Nm.