Withdrawal
1. Disconnect the license plate light connector.
2. Loosen the nut (1) bumper amplifier.
3. Loosen the nuts (2) bumper plates.
4. Remove the bolt (3) fastening the bracket to the cross member of the frame.
5. Remove the bolt (4) fastening the bracket to the frame side member.
6. If installed, remove the bolts (1) attaching the trailer tongue to the bumper.
7. Remove the rear bumper from the vehicle.
Installation
1. Install the rear bumper on the car.
2. If removed, install the trailer drawbar, tighten the mounting bolts.
3. Install the bumper booster nut. Tighten the nut. Tightening torque 50 Nm.
4. Install the bumper plate nuts. Tighten nuts. Tightening torque 90 Nm.
5. Establish a bolt of fastening of an arm to a crossbar. Tighten the bolt. Tightening torque 100 Nm.
6. Establish a bolt of fastening of an arm to a side member. Tighten the bolt. Tightening torque 40 Nm.
7. Connect the license plate light connector.