Withdrawal
1. Remove the tailgate handle trim, see "Adjustment".
2. Release the lock rod retainers on both sides of the trim, see illustration. "Adjustment".
3. Remove three bolts (1) handle attachment. Tightening torque 25 Nm.
4. Remove the tailgate spoiler.
5. Remove the handle.
Installation
6. Installation is carried out in the reverse order. After installation, adjust the operation of the lock.
Adjustment
1. Lower tailgate.
2. Remove the bolts (1) tailgate handle pads. Tightening torque 9 Nm.
3. Use a flat-blade screwdriver to release the trim tabs that are located directly below the trim in the areas (3). Remove the trim (2).
4. Release the latch (3) lock rods on the right side of the lining.
5. Release the latch (4) lock rods of the spruce side of the lining.
6. Adjust the position of the lock by moving the rod seat in the retainer. Move both saddles the same distance.
7. Fasten the clips.
8. Close tailgate. Check the security of the bead lock.
9. Open the board, check the freedom of its movement.
10. If necessary, repeat steps 6-9.
11. Establish an overlay of the handle of a back board.