Withdrawal
1. Remove glass of the hatch.
2. Remove the sunroof trim.
3. Remove the ceiling panel.
4. Remove the sunroof.
5. Remove drain hoses.
6. Disconnect sunroof wiring connector.
7. Turn away nine bolts of fastening of a frame of the hatch.
8. Remove the sunroof frame.
Installation
9. Installation is carried out in the reverse order. The order of tightening the mounting bolts is shown in the figure.
Note: before installing the bolts, install the sunroof on the pilot holes A and B using a 2 mm drill.
10. If necessary, synchronize the sunroof motor. Tightening torque 9 Nm.
The order of tightening the bolts of the hatch frame