Withdrawal
1. Remove the ceiling panel.
2. Disconnect connectors (5) And (6).
3. Remove sunroof wiring.
Installation
Attention: strictly observe the route of laying the wire bundle, otherwise the wires may be pinched in the drive mechanism.
1. Connect the connector (6).
2. Fix the wires on the flanges (7) And (2).
3. Fasten the clips (1) And (3).
4. Loop the wires around the sunroof cable (4).
5. Connect the connector (5) sunroof drive motor.
6. Install the ceiling panel.
7. Check the operation of the mechanism.