Technical data of the cooling system Total information Radiator cap valve opening pressure - 0.95 kgf / cm 2 . The temperature of the thermostat operation is 91°C. Connection tightening torques...
General information about the cooling system The cooling system includes a cross-flow aluminum radiator, thermostat, crankshaft pulley driven coolant pump, and connecting hoses and tubes. The fan of the...
Antifreeze — general information The cooling system is charged with a mixture of water and ethylene glycol. On models 1987-1995, the coolant should be changed every 50,000 km, or every two...
Radiator — removal and installation 1. Disconnect the battery from the ground. 2. Drain the liquid from the cooling system, disconnect all hoses from the radiator (see photo). 3. On models with...
Thermostat — check and replacement Attention! Driving without a thermostat is highly discouraged as the processor unit will run in open loop mode, resulting in increased fuel consumption and...
Cooling fan and fan clutch — removal and installation 1. The fan of the cooling system is changed if the blades are damaged or deformed. The hydraulic clutch for turning on the fan on a cold engine, or at high...
Coolant Pump — Check 1. If after any of the three checks below, a malfunction of the coolant pump is found out, then it must be replaced immediately. 2. Warm up the engine. Squeeze...
Coolant pump — removal and installation 1. Disconnect the battery from the ground. 2. Drain the coolant. 3. Loosen the nuts/bolts of the fan pulley and remove the drive belt. 4. Loosen the clamps and...
Coolant reservoir — removal and installation 1. Disconnect the hose from the tank. 2. Loosen the screws and remove the tank (see photo). 3. Wash the tank with soapy water and install in reverse order.