Using a Phillips screwdriver, unscrew the two screws (one on each side) fixing the rear part of the floor tunnel lining.
Raising the parking brake lever, move the lining back..
... disengaging the latches from the front of the cladding.
Remove the back of the tunnel lining from the parking brake lever.
Overcoming the resistance of the clamps, we take out the frame of the cover of the gear lever from the opening of the lining and raise the cover.
Using a Phillips screwdriver, unscrew the rear mounting screw..
... and two screws (one on each side) front fastening of the front part of the floor tunnel lining.
Raising the front part of the lining, we pass the frame of the gear lever boot through the hole in the lining.
We disconnect the cigarette lighter wire blocks and remove the front part of the floor tunnel lining.
Install both parts of the floor tunnel lining in reverse order.