Car engine repair Chevrolet Lacetti 1

Engine device
Engine (front view of the car): 1 - catalytic converter of exhaust gases; 2 - air conditioning compressor; 3 - bracket for mounted units; 4 - tensioner of the...

Checking the condition and replacing the timing belt
According to the maintenance schedule, check the condition of the timing belt (timing) should be carried out after 30 thousand km, and the replacement of the...

Camshaft oil seal replacement
It is convenient to assess the condition of the camshaft oil seal and, if necessary, replace it when carrying out routine work to check the condition of the...

Replacing the cylinder head cover gasket
We replace the gasket when an oil leak occurs at the junction of the cover with the cylinder head. We work on a cold engine. Remove the top front timing cover...

Removing camshafts and valve lifters
We perform work to replace failed camshafts (wear of the cams, scuffing of the shaft journals) or valve lifters (loss of working capacity), as well as when...

Replacing the front crankshaft oil seal
We replace the front crankshaft oil seal when traces of oil appear on the surfaces of the oil pump cover and the engine oil pan under the auxiliary drive...

Replacement of a back epiploon of a cranked shaft
We replace the rear crankshaft oil seal if there are traces of engine oil leakage.. ... from a hole located below at the junction of the clutch housing with...

Removing the low oil pressure sensor
We remove the sensor to replace it if it fails, check the pressure in the engine lubrication system, and also if an oil leak occurs at the junction of the...

Replacing power unit supports
We replace the support when the rubber breaks or peels off from the metal parts of the support, which can cause knocking when starting the engine and when...

Removal and installation of the engine
We carry out the work if it is necessary to repair the engine or replace it. For the convenience of dismantling the engine, remove the hood (see Removing the...

Replacing the accessory drive belt tensioner pulley
The roller of the automatic tensioner of the auxiliary drive belt is changed when the roller bearing fails. We remove the tensioner for replacement if its...