1. Disconnect the wire from the terminal «minus» battery.
2. Remove the decorative engine cover (see «Removal and installation of a decorative casing of the engine»).
3. Remove the throttle assembly (see «Removal and installation of the throttle assembly»),
4. Remove the accessory drive belt (see «Accessory drive belt replacement»).
5. Remove the rubber cap of the generator power wire tip, unscrew the nut and disconnect the wire from the generator output.
6. Wring out a clamp and disconnect block of a plait of wires from the generator.
7. Turn out the top hairpin of fastening of the generator.
8. Loosen the nut of the lower mounting bolt of the generator.
9. Turn out three bolts of fastening of the lower arm of the generator to the block of cylinders of the engine...
10.... and remove the generator with the bracket (for clarity, shown on the engine removed from the car).
11. Finally turn off a nut of a bolt of the lower fastening of the generator and remove the generator from an arm.
12. Install the removed parts in the reverse order of removal.