1. Disconnect the wire from the terminal «minus» battery.
2. Remove the front wheel liner from the side of the wing to be replaced (see «Removal and installation of fender liner»).
4. Remove the front bumper (see «Removal and installation of a forward bumper»).
5. Remove the side turn signal lamp (see «Side turn signal replacement»).
6. Remove the air box grille (see «Removal and installation of a lattice of a box of an air inlet»).
7. Prying with a screwdriver, pull out the retainer of the piston for fastening the decorative trim to the wing...
8.... and remove the piston.
9. Remove a decorative overlay.
10. Turn out two bolts of the bottom fastening of a wing to a body located under a forward bumper...
11.... and one bolt of the upper wing mounting to the front panel of the engine compartment.
12. Open the front door and turn out the top...
13.... and the lower bolts of the wing to the front pillar.
14. Turn out a bolt of fastening of a wing to a threshold of a body.
15. Turn out three bolts of fastening of a wing to a framework of a motor compartment and remove a wing.
16. Install the front fender and all removed parts in the reverse order of removal.