Rear drive axle of the car Chevrolet Captiva 1

General description and operation of the rear drive axle
Wheel drive shaft The wheel drive shafts are blocks of movable shafts that transmit torque from the differential cup assembly to the rear wheel assemblies....

Specifications of the rear axle
General specifications PROGRAM unit Description Clutch assembly operating voltage Volt 9 ~ 16 Clutch assembly operating temperature range °C -40 ~ +100 Torque...

Table of special tools
J-8059 Pliers for snap ring DT-48254 Rear Drive Shaft Seal Installer J-35566 Seal fixing pliers

Rear Drive Unit (RDM) Schematic
Rear drive unit diagram (RDM)

Arrangement of rear axle components
Rear drive axle 1. cardan shaft 2. Side bracket of differential cup assy 3. Differential cup assy 4. Side cover of a cup of differential assy 5. clutch...

Diagnosis of malfunctions of the rear drive axle
General diagnostics Visual inspection / physical control Inspect aftermarket equipment that may affect the operation of the vehicle. Inspect easily accessible...

Diagnostic Trouble Codes (DTCs)
Diagnostic Trouble Codes Diagnostic trouble code (DTC) Description C0393 (0B) Rear axle clutch solenoid valve control circuit (overcurrent) C0393 (06) Rear...

Cardan shaft — removal and installation
Removal procedure 1. Move gearbox to neutral. 2. Lifting and supporting the car. 3. Put an index mark indicating the position of the driveshaft relative to the...

Wheel drive shaft — removal and installation
Removal procedure 1. Lifting and supporting the car. 2. Remove the rear driveshaft spindle nut. 3. Remove the bolts securing the trailing arm bracket to the...

Rear drive unit — removal and installation
Removal procedure 1. Ignition key in the OFF position. 2. Remove the propeller shaft and wheel drive axles from the rear drive unit. Cm. " Cardan shaft and...

Wheel drive shaft — repair
Necessary equipment J-8059 Thrust ring pliers J-35566 Pliers for clamping the clamp on the casing Procedure for dismantling 1. Remove the drive shaft from the...

Rear drive unit — repair
Procedure for dismantling 1. Place a drain pan under the rear drive unit. 2. Remove the drain plug from the bottom of the rear drive unit and the fill plug...