Withdrawal procedure
1. Remove the gearbox from the car. See Section 5B, "Five-speed manual gearbox".
2. Remove the bolts securing the concentric clutch release cylinder.
3. Disconnect the tube from the concentric clutch release cylinder.
Important: When removing the sleeve, do not apply excessive force.
4. Remove the bushing from the tube of the concentric slave cylinder.
5. Remove the pipe from the concentric clutch release cylinder.
6. Remove the O-ring and concentric clutch release cylinder.
Installation order
1. Install O-ring and concentric slave cylinder.
2. Fit the hydraulic drive tube fitting and tighten the cylinder mounting bolts.
Tighten
Tighten the clutch release cylinder mounting bolts to a torque of 8 ~ 12 Nm (71~106 lb-in).
3. Tighten the hydraulic hose fitting.
Tighten
Tighten the union to a torque of 16 Nm (12 lb-ft).
4. Install the sleeve on the tube of the concentric slave cylinder.
5. Install the gearbox in the car. See Section 5B, "Five-speed manual gearbox".