Withdrawal procedure
Before disconnecting the hose from the reservoir of the hydraulic clutch system, drain the fluid from the reservoir.
1. Remove the locking collar from the clutch pedal.
2. Remove pushrod from clutch pedal.
3. Remove the clamp securing the hose to the master cylinder fitting.
4. Remove hose from master cylinder fitting.
5. Disconnect the master cylinder tube.
6. Tighten the master cylinder nuts.
7. Remove master cylinder.
Installation order
1. Install clutch master cylinder and secure with nuts.
Tighten
Tighten the master cylinder nuts to 23 Nm (17 lb-ft).
2. Connect the master cylinder tube.
3. Attach the hose to the master cylinder fitting.
4. Attach the hose clamp to the master cylinder fitting.
5. Insert pushrod into clutch pedal.
6. Install the locking clamp on the clutch pedal.
7. Remove air from the hydraulic drive system. See «Removing air from the hydraulic drive system» in this section.
8. Add liquid to the tank to the required level.