Withdrawal procedure
1. Disconnect the cable from the negative battery terminal.
2. For HFV6 3.2L or 2.0S Diesel, remove the ECM bracket.
3. Remove electrical connector (4) output shaft speed sensor from the output shaft speed sensor.
![](https://www.chevyman.ru/img/captiva/2765.jpg)
4. Loosen the crankshaft speed sensor mounting bolt.
5. Remove the output shaft speed sensor from the transaxle assembly.
6. Remove the output shaft speed sensor o-ring. Discard the O-ring.
![](https://www.chevyman.ru/img/captiva/2766.jpg)
Installation order
1. Lubricate the output shaft speed sensor O-ring with transmission fluid.
2. Install a new output shaft speed sensor o-ring to the output shaft speed sensor.
3. Install the output shaft speed sensor to the transaxle assembly.
4. Install the crankshaft speed sensor mounting bolt.
Tighten
Tighten the output shaft speed sensor bolt to 6 Nm (53 lb-in).
![](https://www.chevyman.ru/img/captiva/2767.jpg)
5. Connect electrical connector (4) to the output shaft speed sensor.
6. For HFV6 3.2L or 2.0S Diesel, install the ECM bracket.
7. Connect the wire to the negative terminal of the battery.
![](https://www.chevyman.ru/img/captiva/2768.jpg)