Removal procedure
1. Disconnect the negative battery cable.
2. Disconnect the mass air flow sensor connector (MAF).
3. Loosen the clamp and disconnect the flexible air intake duct from the MAF sensor housing.
4. Remove the air cleaner housing screws.
5. Remove the housing from the ball stud and remove the air filter assembly.
Installation procedure
1. Install the lower air cleaner housing onto the ball stud.
2. Install the air cleaner housing screws.
Tighten
Tighten the air filter housing bolt to 6 Nm (53 lb-in.).
3. Install the air intake duct assembly.
4. Fasten loose clamps.
