Electrical equipment of the gasoline engine FAM II 2.4D Chevrolet Captiva 1

General description and operation of the system
Battery Batteries are sealed as standard on all vehicles. There are no ventilation plugs in the lid. The battery is completely sealed, with the exception of...

Technical characteristics of the electrical equipment of the engine
Starter Specifications Description Unit Standard Type - permanent magnet gear reducer Capacity; Volume; Performance; Power; Working volume kW 1,4 No load test...

Schematic and wiring diagrams of starting and charging
Engine start system Charging system

Diagnostics of the electrical equipment of the engine
Starter does not crank engine Checkpoints operation, action Low battery voltage Charging the battery or replacing it. Loose, rusted, or damaged battery cable....

Starter noise
Start the engine. If the starter is malfunctioning, it can be corrected as follows. Before performing the following operations, make sure that the battery is...

Battery test under load
1. Check the battery for visible damage, such as a broken case or cap, which could cause loss of electrolyte. If there is visible damage, replace the battery....

Generator Output Test
1. Perform a generator systems test. follow the paragraph «Checking Generator Systems» in this section. 2. Replace the alternator if it fails the test. follow...

Checking Generator Systems
During normal operation, the generator warning light comes on when the ignition is in the RUN position and turns off when the engine is started. If the lamp...

Removal and installation of the generator
Removal procedure 1. Disconnect the negative battery cable. 2. Disconnect the intake air temperature sensor connector (IAT). 3. Remove the air filter assembly....

Removal and installation of a starter
Removal procedure 1. Disconnect the negative battery cable. 2. Remove the transaxle rear mount bracket assembly. See section 1C1, mechanical part of the engine...

Battery pack and battery shelf
Removal procedure 1. Disconnect the wire coming from the negative battery terminal, and then disconnect the wire coming from the positive battery terminal. 2....

Disassembly and assembly of the starter
Disassembly procedure 1. Remove the starter. follow the paragraph «Starter» in this section. 2. Remove the starter through screws. 3. Remove the commutator end...

Disassembly and assembly of the generator
Disassembly procedure 1. Remove the generator. follow the paragraph «Generator» Car maintenance of this section. 2. Make a mark on the front side to facilitate...