Engine mount (right side)

Necessary equipment

DW 110–060 Engine clamp

Removal procedure

Attention! Raise the engine just enough to take the load off the engine mount, otherwise damage to the mount and failure of the lifting equipment may result.

1. Support the motor assembly using the DW110-060 motor jig.



2. Remove the engine mount adapter retaining bolts from the engine mount support bracket.

3. Remove the lock bolt and nuts of the side bracket of the engine mount frame.

4. Remove the engine mount.

Installation procedure

1. Install the engine mount.

Tighten

Tighten the retaining bolt of the engine mount frame side bracket to 100 Nm (73,8 lb-ft), and nuts with a torque of 90 Nm (66,4 lb-ft).

Tighten the engine mount bracket retaining bolts to 50 Nm (37 lb-ft).

2. Remove engine jig assembly DW110-060.