The spare wheel, jack and other tools are stored in the luggage compartment and under the rear bumper.
Some models use a jack with a handle.
Your vehicle's tool kit may differ from what is described in this manual.
Warning: When storing the jack, spare wheel, tools and equipment must be fixed in place.
Do not leave the spare wheel, jack or other tools inside the vehicle.
Tools that are not properly secured can be dangerous to passengers in the event of an emergency braking of the vehicle or an accident.
Preparing the jack and tools for work
1. Open the back door.
2. Raise the floor deck and locate the wing bolt.
3. Remove the wing bolt from the jack by turning counterclockwise.
4. Remove the jack and tool bag.
5. Remove the straps holding the tool bag. Then remove the wheelbrace or jack handle from the bag.
Spare wheel removal
1. Use a slotted screwdriver to pry open the plug above the rear bumper.
2. Use the wheelbrace to loosen the bolt securing the spare wheel.
3. Disconnect the spare wheel cable under the rear bumper.
4. Remove the spare wheel.
Note: The jack and other tools should be placed under the luggage compartment floor to prevent abnormal noise while the vehicle is in motion.
Characteristics of the jack. Maximum working load: 900 kg.
Warning: This jack has been designed specifically for this vehicle model.
It is not recommended to use it for other car models.
When working with a jack, it must not be allowed to exceed its maximum allowable load.
Use of this jack on other vehicles may damage the jack, damage the vehicle, or cause personal injury.