Removal procedure
1. Disconnect the cable from the negative battery terminal.
2. Remove the dashboard. See Section 9E, Instrumentation/Driver Information System.
3. The X-BCM can be seen through the hole in the bracket; insert your hands into the hole along the arrow.
4. Detach the clips on both sides of the X-BCM and remove the two nuts through the hole.
5. Pull the bracket out through the hole.
6. Disconnect electrical connector.
7. Pull out the X-BCM through the hole.
Important: Perform SPO reprogramming when replacing X-BCM.
Installation procedure
1. Connect electrical connector.
2. Install the X-BCM module and bracket with nuts through the hole.
3. Install instrument cluster. See Section 9E, Instrumentation/Driver Information System.
4. Connect the wire to the negative terminal of the battery.