Removal procedure
1. Disconnect the cable from the negative battery terminal.
2. Pry off the glass of the interior light by inserting a screwdriver into the recess along the edge of the glass.
3. Loosen the screws and remove the interior light housing from the headlining.
4. Disconnect electrical connector.
5. Remove lamp.
Installation procedure
1. Install replacement lamp.
2. Connect electrical connector.
Note: Direct contact of dissimilar metals can lead to rapid corrosion. Use proper fasteners to prevent premature corrosion.
3. Install the dome light housing to the headlining with the screws.
Tighten
Tighten the interior lamp screws to 2 Nm (18 lb-in).
4. Install the interior light glass to the housing.
5. Connect the wire to the negative terminal of the battery.