Withdrawal procedure
1. Raise the vehicle and place it on the supports provided for this purpose. Leave the levers hanging freely.
2. Remove the wheel. See Part 2E. Tires and wheels.
3. Remove the suspension arm ball joint to steering knuckle nut and cotter pin.
4. Disconnect the ball joint from the steering knuckle.
5. Remove the bolts and nuts securing the suspension arm to the frame.
6. Remove the lever.
Installation order
1. Install the front bolt and nut securing the suspension arm to the frame.
Tighten
Tighten the front suspension arm bolt and nut to 120 Nm (89 lb-ft).
2. Install the rear suspension arm-to-frame bolts and nuts.
Tighten
Tighten the rear suspension arm bolts and nuts to 70 Nm (52 lb-ft).
3. Install the suspension arm ball joint to steering knuckle nut and cotter pin.
Tighten
Tighten the suspension arm ball joint bolt to 10 Nm (89 lb-in).