Necessary equipment
Steering wheel puller KM-210-A
Withdrawal procedure
1. Disconnect the negative battery cable.
2. Remove the airbag module (SIR). See section 8B, "Airbags".
3. Remove the steering wheel nut.
Important: To properly install the steering wheel, make appropriate marks on the steering column shaft and steering wheel.
4. Remove the steering wheel using the steering wheel puller KM-210-A.
Installation order
1. Align the corresponding marks on the steering wheel and steering column shaft. Turn the turn signal off cam on the steering wheel to the left.
2. Loosen the steering wheel nut.
Tighten
Tighten the steering wheel nut to 41 Nm (30 lb-ft).
3. Install the airbag module (SIR). See section 8B, "Airbags".
4. Connect the negative battery cable.