Withdrawal procedure
1. Drain the fluid from the power steering reservoir.
2. Remove the fluid reservoir screws.
3. Loosen the hose clamps and remove both hoses from the fluid reservoir.
Installation order
1. Install the fluid reservoir on the reservoir bracket.
2. Attach both hoses to the fluid reservoir and secure the hose clamps.
3. Install the fluid reservoir with bolts.
Tighten
Tighten fluid reservoir screws to 9 Nm (80 lb-in).
Note: Always use DEXRON®-IID Power Steering Fluid for topping up or complete fluid changes. The use of an unsuitable fluid will damage hoses and seals and result in leakage.
4. Fill reservoir with power steering fluid.
5. Make sure there is no leakage. If a leak is found, correct its cause and bleed the system. See «Bleeding the power steering system» in this section.