Removal procedure
1. Remove trim panel from dashboard.
2. Remove trim panel. See section 9E, "Instruments/driver information system".
3. Remove the stop light switch. See procedure «Stoplight switch» in this section.
4. Disconnect the retainer from the vacuum booster pusher.
5. Remove the nut from the top of the brake pedal lever.
6. Remove the brake pedal.
7. Remove the brake pedal cover from the brake pedal.
Installation procedure
1. Install a new pedal cover if necessary.
2. Lubricate the pedal lever with grease.
3. Install the nut on the top of the brake pedal arm.
Tighten
Tighten the nut securing the brake pedal lever to the bracket to 18 Nm (13 lb-ft).
4. Install the retainer on the brake pedal lever.
5. Install the stop light switch. See procedure «Stoplight switch» in this section.
6. Attach the brake light switch with connector.
7. Install trim panel. See section 9E, "Instruments/driver information system".