Removal procedure
1. Disconnect the cable from the negative battery terminal.
2. Pry off the glass of the individual lighting cover by inserting a screwdriver into the recess along the edge of the glass.
3. Loosen the screws and remove the individual light housing from the headlining.
4. Disconnect electrical connector.
5. Remove the power sunroof control switch.
Installation procedure
1. Install the power sunroof control switch.
2. Connect electrical connector.
Note: Direct contact of dissimilar metals can lead to rapid corrosion. Use proper fasteners to prevent premature corrosion.
3. Install the individual lighting dome light housing into the headlining with the screws.
Tighten
Tighten the housing screws of the individual lighting dome with a torque of 2 Nm (18 lb-in).
4. Install the glass of the ceiling lamp for individual lighting on the body.
5. Connect the wire to the negative terminal of the battery.