The air filter and its air duct are removed if they are damaged and to gain access to other units in the engine compartment.
1. Disconnect the wire from the terminal «minus» battery.
2. Squeeze the latch.
3.... and disconnect the wiring harness connector from the mass air flow sensor.
4. Loosen the clamp screw of the air inlet sleeve...
5.... and remove the sleeve from the air filter nozzle.
6. Pull the air filter housing up...
7.... and remove the lower mounting pin of the air filter housing...
8.... from a rubber bushing on the engine compartment frame bracket.
9. Pull the air filter housing side mounting pins out of the rubber bushings on the side of the engine compartment frame.
10. Disconnect the air filter connection from the air duct connector...
11.... and remove the air filter.
12. In the engine compartment, unscrew the bottom...
13.... and side screws for fastening the air duct sealing shield.
14. Pull out the piston core of the air duct sealing plate and remove the piston.
15. Remove the right front wheel liner (see «Removal and installation of fender liner and wheel mudguards», With. 261).
16. In the right wheel arch, remove the upper air duct holder from the hole in the bracket...
17.... and the lower holder - from the rubber bushing of the spar.
18. Wring out a sealing guard of an air duct and extend the connecting coupling of an air duct in a wheel arch.
19. Pry off the air duct mounting retainer and disconnect the retainer from the engine compartment frame bracket...
20.... then remove the air duct.
21. Install the air duct and air filter in the reverse order of removal.