Vehicle exhaust system Chevrolet Aveo 2 (T300)

Design features of the exhaust system
Exhaust gases are removed from the engine through the collector (exhaust manifold combined with catalytic converter), downpipe 8 (pic. 5.8), additional 14 and...

Replacement of pillows of a suspension bracket of system of release of the fulfilled gases
The rubber suspension pads of the exhaust system are replaced if, due to their damage or excessive deformation, the system elements begin to knock, in contact...

Replacement of the main and additional mufflers
You will need: socket head «at 13», hacksaw or cutting machine - «Bulgarian». The main and additional mufflers, together with pipes, are a non-separable unit....

Downpipe replacement
You will need: socket head «at 13», split wrench «at 22». 1. Disconnect the wire from the terminal «minus» battery. 2. Remove the crankcase protection (see «...

Removal and installation of the collector, replacement of its gasket
You will need: socket heads TORX E10, TORX E12, split wrench «at 22». 1. Remove downpipe (see « Downpipe replacement »). 2. Remove the thermal screen of the...

Removal and installation of thermal screens
You will need: socket heads TORX E10, TORX E12. During engine operation, the exhaust gas system heats up to a high temperature, therefore, in case of severe...

Removing the thermal screens of the main and additional mufflers
You will need a key «on 10». 1. Remove the main and additional mufflers (see « Replacement of the main and additional mufflers »). NOTE: If it is not necessary...