it is necessary to remove the cover from the roof lining, but this can damage the plastic retainers of the cover and scratch the surface of the lining. Therefore, to remove the cover, it is more convenient to remove the cover assembly with the cover, and only then disconnect the cover from the cover. To do this, perform the following operations.
1. Disconnect the wire from the terminal «minus» battery.
2. Pry off the rear edge of the roof lining...
3.... and take it away from the upholstery.
4. Disconnect the wiring harness connector from the dome light connector.
5. Press out the plastic retainer...
6.... and disconnect the wiring harness block from the holder on the trim.
7. Disconnect the pads of the microphone wiring harnesses and remove the overlay assembly with the cover.
8. On the inside of the lining, press the latch...
9.... and disconnect the cover from the lining.
10. Establish a plafond of illumination of salon in an order, the return to removal.