2. Remove the toothed belt.
3. Remove the rear of the timing case
4. Disconnect the oil pressure sensor connector.
5. Remove the crankshaft position sensor.
6. Remove the oil pan.
7. Remove the oil receiver and bracket mounting screws.
8. Remove the oil pump mounting screws.
9. Carefully remove the oil pump and gasket.
10. Clean the oil pump and engine block surfaces where the gasket is to be installed.
11. Remove the safety valve screw.
12. Remove relief valve and spring.
13. Remove the screws from the rear of the timing case.
14. Remove the rear of the timing case.
15. Clean the oil pump housing and all its parts.