Car Maintenance Chevrolet Aveo 1.5 (T250)

Maintenance intervals between services
Vehicle operation under normal conditions Vehicle operation in difficult conditions When operating a car in difficult conditions, a reduction in the intervals...

Vehicle inspection and system check
Inspect the vehicle to check the condition of its parts in the following order: engine compartment; the bottom of the car; body - additional equipment; road...

View of the engine compartment
The engine compartment of a car with a 1.5L SOHC engine 1. Air filter 2. Engine oil filler cap 3. Supply reservoir for hydraulic brake and clutch systems 4....

Checking connections and seals
Checking tightness of joints and seals Check the engine compartment for loose components, cracked or kinked vacuum hoses, faulty plugs, connectors, and any...

Checking the cooling system
The cooling fans are actuated by the engine control module via the low speed and high speed cooling fan control relay for models without air conditioning, or...

Engine oil level control
1. Before checking the engine oil level, park the vehicle on a level surface and warm up the engine to operating temperature. 2. After stopping the engine,...

Visual inspection of components and systems in the lower part of the car
To carry out all the checks described in this section, you must raise the car at a level above the head. Inspect the underside of the vehicle for loose...

Checking the oil level in the gearbox
Convenient for visual inspection (the car is raised) check the oil level in the manual transmission. Checking the oil level in the manual transmission Unscrew...

Road test
Checking the health of the seat belts Fasten the seat belts on the front seats, and then open the locks. Fasten the seat belts in the rear seats, and then open...

Changing engine oil and oil filter
1. Warm up the engine. 2. Remove the filler cap (1). 3. Place a container for draining used oil under the engine and unscrew the plug (2) drain hole. Reinstall...

Checking and adjusting the brake fluid level
The TJ level should be between the MAX and MIN·marks. If the level is below the MIN·mark, add the required amount of TJ. The brake system uses brake fluid type...

Checking the fluid level in the hydraulic power steering
The power steering fluid level is checked with the engine off. The fluid level must be between the MAX and MIN·marks. If the fluid level is below the MIN·mark,...

Air filter replacement
1. Loosen the screws (1) and remove the air filter housing cover (2). 2. Replace filter element. 3. Install the cover (2) and tighten the screws (1). 1. Air...

Replacing spark plugs
1. Disconnect the negative battery terminal. 2. Remove the screws (1) decorative cover fasteners (2) engine. Remove the cover (2). 1. Screw. 2. Decorative...

Checking the V-ribbed belt for wear and damage
If the following damage is present, replace the V-ribbed belt. A. New V-ribbed belt. B. Worn V-ribs of the belt - the edges are pointed (the new one has a...

Checking and adjusting the timing belt tension on the 1.5L SOHC engine
Adjustment 1. Disconnect the negative battery cable. 2. Disconnect the supply air temperature sensor connector. 3. Disconnect the air duct from the throttle...

Replacing the timing belt in the 1.5L SOHC engine
Withdrawal 1. Disconnect the negative battery cable. 2. Disconnect the supply air temperature sensor connector. 3. Disconnect the air duct from the throttle...

Replacing the Timing Belt on a 1.6L DOHC Engine
Withdrawal To remove the timing belt, follow the instructions below: disconnect the negative terminal of the battery; disconnect the intake air temperature...

Notes on Adjusting the Automatic Timing Belt Tensioner
After installing the timing belt, turn the coolant pump clockwise until the tensioner pointer aligns with the mark on the tensioner mounting bracket. Tighten...

Locations for jacking
Places for installation of cantilever supports of a stationary lift. Floor jack installation locations. Places for installing a jack to raise suspension...

Service of brake systems
Front brake check Check brake pad thickness - minimum brake pad thickness (with metal plate): 7 mm. Checking the brake disc The thickness of the brake disc is...

Adjustment of all 4 wheels of the car
Proper wheel alignment is necessary to ensure the following vehicle properties: Self-resetting of the wheels when the car exits the turn and maintaining the...