Adjustment of the mechanism of a gear change

1. Disconnect the negative battery cable.

2. Place the shift lever in neutral position.

3. Loosen the stem clamp bolt.

4. Remove the adjusting hollow insert from the shift lever cover.

5. Rotate the stem and fully insert the 5mm gauge pin into the adjusting hole.

6. Remove a cover of the gear lever.

7. Pull the case up to access the mechanism.

8. Set the shift lever to the left of the neutral position.

9. Insert a 5mm finger into the holes to ensure that the shift lever is aligned with its body.

10. Tighten the stem clamp bolt to 14 Nm.

11. Remove the locking pin from the adjusting hole.

12. Screw on the plug.

13. Remove the locking pin from the shift lever.

14. Install the cover on the console.