Removal procedure
1. Remove the large boot strap.
2. Remove the small collar of the boot.
3. Remove grease from the pivot housing.
4. Remove the shaft retaining ring using a clamp tool.
5. Disconnect the drive shaft from the pivot assembly.
6. Remove boot from hinge assembly.
Attention: do not disassemble the outer CV joint. The parts are tightly fitted and cannot be serviced separately. Incorrect reassembly can not only shorten the life of the assembly, but also lead to very dangerous consequences.
Installation
1. Install a new small collar on the boot. Don't snap.
2. Install the cover on the drive shaft.
3. Install the swivel assembly on the drive shaft.
4. Install the retaining ring on the drive shaft using a clamp tool.
5. Fill the swivel assembly with the recommended grease in the amount of 120-140 g. Fill the three-stud with the recommended grease in the amount of 120-140 g.
6. Install a new large boot clamp.
7. Secure the clamp with the boot clamp tightener.
8. Fasten the new small boot clamp with the boot clamp tightener.