Withdrawal
1. Remove the drive shaft.
2. Remove the large boot strap.
3. Remove the small collar of the boot.
4. Remove grease from the hinge.
5. Remove the boot from the hinge housing.
Attention: do not disassemble the outer CV joint. The parts are tightly fitted and cannot be serviced separately. Incorrect reassembly can not only shorten the life of the assembly, but also lead to very dangerous consequences.
Installation
1. Install boot on drive shaft.
2. Fill the hinge boot with the recommended grease in the amount of 110-130 g. Fill the hinge with the recommended grease in the amount of 110-130 g.
3. Install new clamps.
4. Clip in the new clamps using the boot clamp tightener.
5. Remove the drive shaft.